Force Flow Foot Hooks
Pair of bolt-on hooks. Locks the back foot in for hard carves without pinching the pad.
FOModel by @forceflow on MakerWorld
Printed to order · 48 hr
Make your board yours
Printed parts, custom batteries and full builds for most boards. Pick a colour, change a detail, or send us a file — everything is made to order on machines we run ourselves, so your board does not have to look like everyone else’s.
48 hr
Standard turnaround on stock parts
In-house
Design, print, packs and VESC config under one roof
Any board
Stock fitments plus custom work to order
Colour
Stock and library colours, or we add yours
In stock now
Browse the shop →
Rim Saver
Wraps the rim to protect your hub from rocks and other impacts. Flexes on a hit instead of cracking.
Rail Guard End Caps
Sacrificial caps for the rail ends. Cheap to replace after a slide.
NOModel by @nosedive_nate on Thingiverse
Custom prints
Send us your file
STL, STEP or 3MF. We check wall thickness and orientation before anything goes on a plate, and we tell you if a part will not survive a footpad impact. Bulk runs for group buys are priced separately.
1Upload — we mesh-check it and flag thin walls
2Pick a material and infill, see the price move
3Approve, and it ships inside 48 hours
Instant quote
Drop a model here
STL, STEP or 3MF, up to 120 MB
Material
Infill35%
Standard for hooks and guards.
Estimated, per part
£24.68
Battery building
We build packs too
Custom packs, rebuilds and repairs — cell choice, fusing and fitment worked out with you before anything gets welded. High-drain cells when you want torque, high-capacity when you want the miles, and an honest answer about which one your riding actually needs.
Every pack is spot welded, fused per group, tested for capacity and logged before it goes back in the board. If yours has a fault rather than a design problem, we will try to fix it first.
VESC support
And the electronics
Wiring, custom looms, controller configuration and fault-finding on VESC-based builds. Correct gauge for the current, routed clear of rail edges and heat, and limits set to your pack rather than left at defaults.
If a board is throwing faults or a build has stalled part-way, send us what you have and we will work out what it needs.
Builds we worked on
Printed parts, custom packs and VESC work — three boards we saw all the way through.
Pint V full build
A standard Pint, rebuilt from the ground up
VESCed with a Floatwheel drop-in kit, a custom 21700 P50B pack built to fit, and custom laser etched rails to show its VESC roots.
GTS refresh
Refreshing a pre-loved GTS
Custom rim savers printed to fit and the mag handle re-lined, bringing a well-used board back to something worth riding daily.
XLV frame design
A folded sheet metal frame for the XLV
Designed for Luke Massey to take his XLV project into volume production — a folded sheet metal frame that swaps machined parts for stamped and bent stock, so units can be made in quantity rather than one at a time.
Event awards
Medals and trophies for the 2026 season
Awards for Shred the Shires 2026 and the medals for the EOL Finals. Multi-colour medals printed in batches with the artwork built into the part rather than stuck on afterwards, so nothing peels off a lanyard by the end of the day.
The trophies were printed on a Sonic Fusion 4K Mini, cleaned up and mounted on turned wooden bases.
One of them was hand painted as a special raffle prize, raising money for a local charity.
